Stone engraving machine is a machine that specializes in calligraphy and painting on natural stone, glass and ceramics. This is a high-tech automatic computer-controlled engraving equipment, applied in the stone carving industry, of course, the decoration industry, the inscription industry, etc., it is also necessary to engrave the engraving machine, so that the object being carved can be more artistic. If you use an engraving machine, what should I do if something goes wrong?
If the machine fails, you have to analyze the fault and see what is causing the machine to malfunction. Is there any good solution? In the event of a machine failure, an alarm is issued, and an overtravel alarm is issued indicating that the machine has reached its limit during operation. If you check it, you have to see if the graphic size of the design is beyond the processing range. Also check if the motor shaft and the screw connection line are loose. If it is loose, you need to tighten the screw. Some faults are also caused by the fact that the machine and the computer are not properly grounded, so correct them. If the coordinate value is beyond the range of the software limit value, the coordinate value must be returned to the value.
In fact, the machine starts the overtravel alarm, and all the motion axes are automatically set in the electric state. As long as the manual direction key is pressed, the link movement state is restored at any time when the machine leaves the limit position. Pay attention to the direction of movement when moving the table, and you must stay away from the limit position. To solve the machine failure, find a stone engraving machine manufacturer to solve it better.
